Bunk Bed Assembly Instructions

(Updated 5/6/06)

The bottom front and back rails are assembled the same way as the top rails.  From the back insert the one 4" carriage bolt into the bottom hole of each back leg.  Place the back rail between the ladder ends.  Place a washer, lock washer and nut on each of the bolts and loosely hand tighten the nuts.  From the front insert the 5" carriage bolt into the bottom hole in the front legs.  From the inside place the front rail between the ladder ends.  Place a washer, lock washer and nut on each of the bolts and loosely hand tighten the nuts.  Insert the bed slats between the rails, evenly spacing them apart.  You can now completely tighten the carriage bolts.  Fasten the bed slats to the rails using 2½” screws.  Fasten the back rail to the back legs with 1-5/8" screws.  Fasten the front rail to the front legs with 2½” screws.  The bunk is now complete

Included in this Shipment

(1) Front rail (2x6 w/2x2 ledge)

(1) Back rail (1/2” plywood w/2x2 ledge)

(4) Bed Slats (twin 44”, full 54”, (The Queen Size And Larger Beds Do Not Receive Slats. You Must Purchase A 3/4" MDF Board.)
(2) Carriage Bolts 3/8” x 4”

(2) Carriage Bolts 3/8” x 5”

(4) Each 3/8” Washers, Lock Washers, Hex Nuts

(8) 1 5/8” Drywall Screws

(16) 2½” Drywall Screws